Skip to content
2020-2025 Subaru Outback 2" ATS Suspension Lift Kit - Ironman 4x4

2020-2025 Subaru Outback 2" ATS Suspension Lift Kit - Ironman 4x4

by Ironman 4x4
$999.00 - $999.00
$999.00
$999.00 - $999.00
$999.00

Two inches doesn't sound like much until you're scraping over a rock you would've cleared with this kit installed. Ironman's ATS suspension gives your Outback the clearance to run 245/65R17 tires and the capability to handle rough roads without beating you up in the process.

This is a complete suspension replacement, not a spacer kit. You get front and rear coilovers with extended-travel twin-tube gas struts, performance-tuned springs matched to your load requirements, and all the hardware to install it. The system is built specifically for crossovers like the Outback, so it rides like it should for daily driving while giving you the extra height when you need it.

What's Included

  • Front ATS coilovers with extended travel gas struts
  • Rear ATS coilovers with extended travel gas struts
  • Subframe spacer kit
  • All mounting hardware for installation

Fits These Vehicles

  • 2020-2025 Subaru Outback (6th Generation)
  • All trims: Base, Premium, Limited, Touring, Onyx Edition XT, Wilderness
  • Does not work with electronically controlled dampers

Spring Load Options

Choose springs based on how you actually use your Outback. Medium load works for most people who carry gear on weekends but drive unloaded during the week. Heavy load (Spec-C) is only for vehicles that carry a minimum of 660 lbs constantly. If you don't keep that weight in the vehicle all the time, the heavy load springs will ride stiff and uncomfortable.

Medium Load capacity:

  • Front: 0-110 lbs additional load
  • Rear: 0-440 lbs additional payload
  • Spring rates: 180 lbf/in (front), 200 lbf/in (rear)

Heavy Load (Spec-C) capacity:

  • Front: 110-176 lbs additional load
  • Rear: 660 lbs to GVM additional payload
  • Spring rates: 190 lbf/in (front), 270 lbf/in (rear)

Installation

Professional installation recommended. This is a full suspension replacement that requires removing factory struts, installing coilovers, and adding subframe spacers. Plan for a full day at a shop that's familiar with Subaru suspension work. Recommended wheel and tire setup after install: 17x8 wheels with +15mm offset, 245/65R17 tires.

Specifications

  • Lift height: 2 inches
  • Front strut travel: 615mm extended, 423mm compressed
  • Rear strut travel: 535mm extended, 351mm compressed
  • Ground clearance increase: Up to 10 inches total
  • Twin-tube gas strut design
  • Nitro gas technology
  • Warranty: 4 years / unlimited miles

Questions about spring loads or installation? Contact us.